加拿大BW新款四合一氣體檢測儀MCXL-4的新價格報價和詳細的參數規格資料,正品行貨型號：MCXL-XWHM-Y-CN,正面標識為GasAlert MicroClipXL。GasAlertMicroClip特點: 針對標準操作和長工作時間操作,分別有 GasAlertMicroClipXT 和 GasAlertMicroClipXL，對兩者區別進行詳細比較。
加拿大原裝正品MC2-4生產線轉為中國之后，加拿大原裝生產在升級電池后，型號改為MCXL-4，BW氣體檢測儀兩款整體外觀一致，使用功能一致，在保持MC2-4氧氣使用年限優點繼續保持外，GasAlertMicroClipXL電池使用時間也從8個小時升級為15個小時，更復合緊急救援使用。
如圖配置為擴散式MCXL-4探槍和手泵的結合，也可選擇BW泵吸式四合一氣體檢測儀
GasAlertMicroClip XL可提供經濟劃算的有毒氣體防護。輕薄小巧型設計使其易于攜帶，并且可使工作人員專注于手頭工作，不受負重影響。
2015加拿大BW新款四合一氣體檢測儀,MCXL-4四合一氣體檢測儀特征:
1.LCD實時顯示氣體濃度的連續。
2.小巧輕便的設計使得它穿著舒適。
3.MCXL-4具備防水。
4.BW氣體檢測儀簡單的自動校準程序。
5.兼容BW microdock II自動測試和校準站。
6.全功能自檢的傳感器，電池狀態，電路的完整性和聽覺/視覺警報啟動。
7.MCXL-4具備18小時的電池壽命。
8.明亮的寬角度的視覺報警。
9.防篡改數據，一個按鈕操作。
10.兼容采樣器機動遠程采樣泵。
11.BW氣體檢測儀配備高噪聲區域內振動報警。
BW2016新款四合一氣體檢測儀MCXL-4特點與優點:
1.MCXL-4令人難以置信的纖巧，佩戴感覺舒適。
2.簡單的單按鈕操作滿足多種氣體的多面性。
3.從視覺上保持與 IntelliFlash 的符合性。
4.MCXL-4異常低的擁有成本。
Self-test: Initiated upon activation Calibration: Automatic zero and automatic span Oxygen sensor: Automatic span upon activation (enable/disable)
User field options: Startup message, Confidence Beep, latching alarms, enable/disable safe display mode, oxygen measurement, combustible sensor measurement, sensor disable, define calibration interval, force calibration, calibration lock, force bump, define bump interval, bump due lock, stealth mode, low alarm acknowledge, language selection, enable/disable automatic oxygen calibration, enable/disable auto zero at startup, define alarm setpoints, span concentration values, define STEL calculation period, IntelliFlash, and Confidence Beep and IntelliFlash Interval.
Detectors that are configured for 1, 2, or 3 gases may contain a dummy sensor in one of the four sensor locations.
1. Gently remove the circular rigidified flex PCB atop the sensor from the metal sensor posts. Take care not to tear the flex cable.
2. Note the placement of the PCB to ensure it is replaced correctly. Remove the two screws on the PCB.
3. Lift the PCB straight up. The oxygen sensor will stay in the front shell. Remove the sensor.
4. On roughly the same spot on the front shell, place the new sensor. Lower the PCB over the oxygen sensor.
5. Carefully replace the circular rigidified flex PCB atop the metal sensor posts. Ensure the plastic sensor post is inserted into the clear plastic hole. Take care not to tear the flex cable.
6. Press down to secure the circular rigidified flex PCB atop the metal sensor posts.Take care not to press down too hard and accidentally activate the detector.
7. To complete the detector.
BW氣體檢測儀性能參數：
1.MCXL-4尺寸：4.4 x 2.4 x 1.1 英寸/ 11.3 x 6.0 x 2.9 厘米
2.重量：6 盎司/ 170 克
3.溫度：-4 至 + 122°F / -20 至 +50°C
4.工作濕度：0-95% 相對濕度（非冷凝）
2015加拿大BW新款四合一氣體檢測儀,MCXL-4四合一氣體檢測儀傳感器:
1.H2S; 0 to 100 ppm (1 ppm
2.CO; 0 to 500 ppm (1 ppm)
3.O2; 0 to 30% (0.1%)
4.可燃?xì)怏w;
0 to 100% LEL (1%)
0 to 5.0% v/v (0.1%
Detection range:
H2S: 0 – 100 ppm (1 / 0.1 ppm increments)
CO: 0 – 500 ppm (1 ppm increments)
O2: 0 – 30.0% vol. (0.1% vol. increments)
Combustible (LEL): 0% to 100% LEL (1% LEL increments) or 0.0% to 5.0% v/v methane Alarm conditions: TWA alarm, STEL alarm, low alarm, high alarm,
multi-gas alarm, over limit (OL) alarm, low battery alarm, confidence beep, automatic deactivation alarm
Audible alarm: 95 dB at 30 cm (1 ft.) (100 dB typical) variable pulsed beeper
Visual alarm: Red light-emitting diodes (LED)
Display: Alphanumeric liquid crystal display (LCD)
Backlight: Activates when the pushbutton is pressed and deactivates after 5 seconds; also activates during an alarm condition)
BW氣體檢測儀GasAlertMicroClip XT XL X3產品結構：
BW四合一氣體檢測儀三者區別：
MC2-4:11.25 x 6.00 x 2.89 cm (4.4 x 2.4 x 1.1 in.)
MCXL-4,MCX3-4:11.25 x 6.00 x 3.22 cm (4.4 x 2.4 x 1.2 in.)
MC2-4重量170 g (6.0 oz.)
MCXL-4:190 g (6.7 oz.)
MCX3-4:179 g (6.3 oz.)
BW氣體檢測儀使用環境：
MC2-4，MCXL-4使用環境：-4°F to +122°F (-20°C to +50°C)
MCX3-4使用環境：-40°F to +122°F (-40°C to +50°C)更能耐低溫。
Instrument dimensions:
XT: 11.25 x 6.00 x 2.89 cm (4.4 x 2.4 x 1.1 in.)
XL-X3: 11.25 x 6.00 x 3.22 cm (4.4 x 2.4 x 1.2 in.)
Weight:
XT: 170 g (6.0 oz.)
XL: 190 g (6.7 oz.)
X3: 179 g (6.3 oz.)
Operating temperature: -4°F to +122°F (-20°C to +50°C)
Storage temperature: -40°F to +122°F (-40°C to +50°C)
Operating humidity: 0% to 95% relative humidity (non-condensing)
Alarm setpoints: May vary by region and are user defined. All setpoints
automatically display during the startup self-test
"
